flashrom

USE флаги

• atahpt - Highpoint (HPT) ATA/RAID controller support
• atapromise - Support for Promise PDC2026x (FastTrak/Ultra)
• atavia - Support for VIA VT6421A SATA controllers
• buspirate-spi - Enable Bus Pirate SPI programmer
• ch341a-spi - Enable WCH CH341A SPI programmer
• dediprog - Dediprog SF100 support
• developerbox-spi - Enable Devloperbox SPI recovery support
• digilent-spi - Enable support for Digilent iCEblink40 development board
• dirtyjtag-spi - Support for DirtyJTAG (a USB-JTAG firmware for STM32 MCUs)
• drkaiser - Enable Dr. Kaiser programmer
• dummy - Enable dummy tracing
• ft2232-spi - Enable ftdi programmer, flashing through FTDI/SPI USB interface
• gfxnvidia - Enable NVIDIA programmer
• internal - Enable internal/onboard support
• internal-dmi - Enable internal DMI decoding rather than use sys-apps/dmidecode
• it8212 - Support for ITE IT8212F ATA/RAID controllers
• jlink-spi - Support for SEGGER J-Link and compatible devices
• linux-mtd - Enable support for Linux mtd SPI flash devices
• linux-spi - Enable support for Linux userspace spidev interface
• mediatek-i2c-spi - Support for Mediatek LCD controllers
• mstarddc-spi - Support for SPI flash ROMs accessible through DDC in MSTAR-equipped displays
• nic3com - Enable 3Com NIC programmer
• nicintel - Support for Intel NICs
• nicintel-eeprom - Support for EEPROMs on Intel Gigabit network cards
• nicintel-spi - Support for SPI on Intel NICs
• nicnatsemi - Support for National Semiconductor NICs
• nicrealtek - Support for Realtek NICs
• ogp-spi - Enable support for OGP (Open Graphics Project) SPI flashing
• parade-lspcon - Enable support for Parade lspcon USB-C to HDMI protocol translator
• pickit2-spi - Support for SPI flash ROMs accessible via Microchip PICkit2
• pony-spi - Enable support for SI-Prog like hardware by Lancos
• raiden-debug-spi - Support for Chrome EC based debug tools - SuzyQable, Servo V4, C2D2 & uServo
• rayer-spi - RayeR SPIPGM hardware support
• realtek-mst-i2c-spi - Enable support for Realtek RTD2142 MST
• satamv - Enable programmer for Marvell SATA controllers
• satasii - Enable programmer for SiI SATA controllers
• serprog - Enable Serial Flasher programmer
• stlinkv3-spi - Enable SPI programmer using STLINK-V3
• test - Enable dependencies and/or preparations necessary to run tests (usually controlled by FEATURES=test but can be toggled independently)
• tools - Install ich_descriptor_tool, a tool for reading descriptor-mode SPI-flash images for Intel chipsets
• usbblaster-spi - Enable support for Altera USB-Blaster dongles